AIRBRUSH REPAIR

By Don Johnson

www.airbrushartistmagazine.com
www.airbrushtechniquemagazine.com

As picture below shows when installing the trigger back into your airbrush (Iwata) hold the trigger (main lever) so that the two posts at the bottom of the trigger (main lever) face the front and back of the airbrush. Insert the trigger (main lever) down into the long opening in the top of your airbrush. Now turn the trigger (main lever) 90 degrees so the posts at the bottom of the trigger (main lever) are now facing the sides of the airbrush. Lower the trigger inserting the posts into the slot inside your airbrush. With this done now tilt the front of the airbrush slightly down ward install the auxiliary lever so that the arch in that lever faces the back of the airbrush see picture #2. To insert the auxiliary lever you must also turn this side ways to get it down into the airbrush than turn it 90 degree's so it ends up as pictured in #2.

Picture 1 below

Picture 2 below

I hope you found this article helpful. Two more great resources to learn more about airbrushing, kustom painting are my airbrush, kustom painting magazines. Check them out via the links below. Until next time "It's just paint" have fun. Airbrush Technique Magazine Airbrush Artist Magazine

Discuss this tutorial on our airbrush forums

Back to airbrush lessons index

Airbrush supplies / Airbrush magazine / Airbrush Tricks and techniques / Airbrush artist / Airbrush Artists / T shirt artist / Airbrush Videos / Airbrush Lessons and Techniques / how to custom paint / Airbrush Forums / Airbrush product review / Airbrush artwork / Legends car racing / Helmet painting