Thread: paint comes out when i push down on trigger

I just got a master G23 the other day and I've been using badger airbrush paint.
When I press down on the trigger I get paint along with the air. Is there anyway to stop this? I've tried reducing the psi but nothing has helped. The trigger is all the way forward and it still has paint coming out. any suggestions?

If the trigger is all the way forward there should be paint coming out..............
I think you mean all the way back with just the air depressed.
If thats the case the needle most likely is not seated in the nozzle correctly allowing paint to flow when it shouldn't

most common cause is either there is a tiny bit of dried paint inside the nozzle or on the end of the needle not allowing it to seat correctly

inspect and clean it again

buy some good airbrush paint to practice with Golden airbrush colors, Comart and you'll find learning much easier

happy holidays