Scuff It
In this How To Airbrush article we'll cover prep of painted, clear coated metal surfaces before adding your art work. Weitten by Don Johnson brought to you by Airbrush Technique MagazineThis is the short version of a tutorial I wrote about surface prep for Airbrush Technique Magazine Extended that I hope you find helpful. This is in general geared toward those rending art on motorcycles, helmets and the like when the surface has already been base coated and cleared.
This takes into account any wax or other substances have already been cleaned from the surface and you are ready to scuff the surface for paint adhesion purposes. The key word here is SCUFF not scratch so a certain degree of care should be taken when prepping a surface for adding your artwork, airbrushing.
The first rule when looking to prepare a surface for custom painting is READ THE TECH SHEET, the second rule is READ THE TECH SHEET for the paint product you will be using. You can save yourself a lot of heart ache by following those simple rules before you jump into any project. In very general terms the procedure as out lined below will work but please check, read the tech sheets that go along with the paint products you will be using.
It this tutorial we'll be going over using Scotch Brite pads for the purpose of scuffing the surface. As I stated above what we want to accomplish here is to scuff the surface (clear coat) we DO NOT want to scratch the surface there is a huge difference. . To just take after the surface with a Scotch Brite pad you might get away a couple times but sooner or later it will bit you and you'll end up with a surface covered with scratches, not good. To help avoid that end result you will find the following very helpful.
For those of you with deeper pockets than mine there is a 3M product made just for use with Scotch Brite pads, "Scuff It". "3M™ Scuff-It™ is an outstanding new prep gel that is designed to clean, degrease and abrade automotive surfaces prior to painting.Used in conjunction with Scotch-Brite™ pads, the Scuff-It™ gel lubricates the pad to ensure a consistent scratch pattern that will greatly improve the adhesion of the paint. Rinses cleanly with water. Convenient "wedge" tube fits into technician's pocket for easy use."
Following along with the Comet method you need to keep your surface wet all the time apply a bit a Comet to the area you intend to scuff and gently have at it with the Scotch Brite pad.
The key with this method is to keep the surface wet all the time and rinse the Scotch Brite pad out often. You want to avoid the pad getting a build up of gunk as that will produce scratches.
Pictured above is our scuffed motorcycle tank all ready for us to add our artwork to. No big scratches a nicely scuffed surface to which the paint should have no problem adhering to. You can see on the masking covering the gas filler hole how shiny that area still looks against our nicely scuffed surface.
Pretty simple basic stuff but if done in correctly the greatest art work, graphic's will not cover the mess underneath them. Your paint is only as good as what you apply it over get off to a great start and scuff the surface correctly.
Copyrights:Airhead Airbrush.Com, Inc. Reserved No part of this tutorial may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, electrostatic, magnetic tape, mechanical or otherwise, without prior permission in writing from Airhead Airbrush. Com, Inc.
Sections
