How To Airbrush A Maltese Cross
Welcome to howtoairbrush.com if this is your first visit we hope you come back often as we will add new how to airbrush, kustom painting articles as often as possible. In this article I’ll be adding a Maltese Cross to a Harley tank which has already been based coated and cleared. Written by Don Johnson sponsored by Airbrush Technique Magazine
What I used in this project: Double action airbrushes, House of Kolor paint, transfer paper, fine line tape, masking tape, hobby knife.
I’m sure there is more ways of kustom painting a Maltese Cross than the way I will be showing you but hopefully you’ll read some techniques you can use in your own airbrush projects.
I start out with a Harley Sporster tank that is ready to have the artwork added to it. Notice the gas filler hole is masked, won't do to get any paint down inside the tank.
Apply your transfer tape so you end up with as few wrinkles as possible; no need to cover the entire tank just the area where the Maltese Cross will be.
I've drawn a Maltese Cross in Abobe Illustrator and printed it off the correct size to fit our project tank.
Now we'll find the center of the tank and draw a reference line on the transfer tape so the design can be centered.
On our design I've traced the design on the back side with a number two pencil. On the original side I find the center of the design and match the two center lines and use tape to hold the design in place. Our design is now centered on the tank. Now go back over the design on the original design with a pen tracing the design again.
With the design orginal removed you can see our Maltese Cross has been transferred onto the transfer paper. Now carefully cut the design out of the transfer paper with a hobby knife.
With the Maltese Cross now exposed I airbrush Orion silver over the entire design and let it flash or dry for about an hour before moving onto the next step.
At this point if there is a logo incorporated in the design add it to the design as I’ve done in the picture above.
I want a silver pin stripe around the outside edge of the Maltese Cross and add 1/8 inch fine line tape around the outside edge.
To add some interesting texture within the Maltese Cross I use a modified marbleizing technique with plastic wrap and base black.If you've added a logo go right over the logo with your texture.
Copyrights :Airhead Airbrush.Com , Inc. Reserved No part of this tutorial may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, electrostatic, magnetic tape, mechanical or otherwise, without prior permission in writing from Airhead Airbrush. Com , Inc.
google ads
Section Widget
